DL Series Embossed Panel Doors
Commercial Steel Door Performance with Decorative Panel Designs
Republic offers a wide variety of embossed panel insulated doors such as our traditional 6-panel design, 8′ 6-panel design with elongated panels, 2-panel colonial design, 4 panel, and 8 panel designs. Doors are available in 18, and 20 gauge cold rolled steel or galvanealed (A60) steel. Face sheets are continuously projection welded to hinge and lock channels on 5" centers. SDI Levels 2 and 3 - Physical performance level A
Features
- 1¾" (44.4) design, rated for light to extra heavy-duty use
- Polystyrene core (1 pound density) 100% bonded to skins to provide exceptional insulation, strength, and flatness
- Hinge edge is non-beveled and reinforced with a full height 16 gauge steel channel projection welded at a maximum of 5" on center with an additional 9 gauge reinforcement plate at each hinge location, providing more than 3/16" (5) of total reinforcement
- 16 gauge flush top and inverted bottom channels projection welded to both skins every 2½" on center
- Lock edge is non-beveled and reinforced with a continuous 16 gauge channel, mortised and cylindrical lock reinforcements are integral 16 gauge reinforcements
- Doors are prepared for 4½" standard or heavy weight, full mortise template hinges
- Non-handed design (square lock edge)
- Come standard with 1½ hour Mylar Underwriters Laboratories fire label
- Doors are thoroughly cleaned, phosphatized, and primed with a coat of force cured rust inhibiting primer that meets and/or exceeds the requirements of ANSI A250.10 (120 hour continuous salt spray test per ASTM B117 and 240 hour continuous humidity test per ASTM D4585)
- Doors are individually packaged and fully plastic wrapped to prevent damage
Available Options
- 14 gauge closer reinforcement (standard option)
- 12 gauge closer reinforcement
- A60 galvanealed, or textured wood-grain (wood grain embossed are available as prime painted only – factory stain not available)
- Continuously welded seamless design or filled seamless design
- Lock edge beveled 1/8" in 2"
- Sizes available: Minimum 2′6" x 6′8", Maximum 3′8" x 7′2" (20 gauge available in 3070 or smaller only)
- 4" hinges (square edge only)
- Half glass light kits (limited sizes available)
- Finish paint (Republic standard and custom colors)
Embossed Door Information




